Skip to content
Bora Haber
Markets
  • US dollar50.44up 0.05%
  • Euro55.34down 0.18%
  • British pound66.55down 0.11%
  • BIST 10011,477down 3.08%
  • Gold (gram)6,051down 3.4%
  • Gold (ounce)US$3,731down 3.44%
  • BitcoinUS$62,793down 1.46%
BREAKING
Law and rights

What to watch for when driving in snow and ice, and when to fit snow chains

Short answer

On snow and ice, slow down, increase following distance and avoid sudden braking or steering. Fit chains when wheels slip and the car can't move, or when signs or officials require it, stopping in a safe place.

Snow and ice sharply reduce tyre grip. Braking distances grow and steering response weakens. Preparation and driving style are therefore the basis of preventing winter accidents. Check current road and weather conditions with the General Directorate of Highways (Karayolları Genel Müdürlüğü) and the General Directorate of Meteorology.

Before you set off

  • Fit winter tyres; winter tyres may be mandatory in set periods and for certain vehicle classes, so check the current rule from the official source.
  • Check tyre tread depth and pressure, battery, wipers, lights and antifreeze washer fluid.
  • Carry chains, a tow rope, a small shovel, a blanket, a torch, a charger and water/food.
  • Keep the tank well filled; clear snow from the windows and roof.
  • Learn about road closures beforehand; postpone the trip if possible.

While driving

  • Reduce speed and increase the gap to the vehicle ahead to several times the normal distance.
  • Use the accelerator, brake and steering gently; avoid sudden manoeuvres.
  • Pulling away in a higher gear at low revs helps traction; use engine braking on descents.
  • Bridges, viaducts, shaded stretches and tunnel exits ice up earlier and treacherously; take extra care there.
  • Do not try to overtake snow-clearing vehicles; keep a safe distance.

When should chains be fitted?

Chains are used in heavy snow and ice when tyres alone cannot provide enough traction. In general, fit them when:

  • The wheels spin freely, or the car cannot climb a slope or keeps sliding.
  • A roadside traffic sign or officials require chains.
  • There is packed snow or an ice layer on the road and the gradient is steep.
  1. Stop in a safe placeChoose a flat spot that won't block traffic; switch on hazard lights and apply the handbrake.
  2. Prepare the chainsUnfold them and check for tangles; ideally practise at home beforehand.
  3. Fit them to the right wheelsThey normally go on the driven wheels (front on a front-wheel-drive car); see your vehicle manual.
  4. Tighten themTension the chains firmly, drive a few metres, then check for slack and retighten.
  5. Drive slowlyKeep to low speed; remove the chains once the road is clear and asphalt shows, otherwise tyres and road are damaged.

Frequently asked questions

Can I drive fast with chains on?

No. Drive at low speed and never exceed the maximum speed stated by the chain manufacturer.

Do I need chains if I have winter tyres?

Winter tyres are enough in most cases, but chains may be needed in heavy snow, on steep slopes, or when a sign or official requires them.

What if I get stranded?

Stay in the vehicle, make sure the exhaust is not blocked by snow and call the 112 Emergency Call Centre. Do not run the engine if the exhaust is blocked.

Where can I learn road conditions?

From the General Directorate of Highways' road information channels and the Alo 159 line.

Source: Karayolları Genel Müdürlüğü

Latest from Agenda

Have a question or spotted a mistake?

Write your question or the error you noticed; our editors will review it. Messages are not published.

What would you like to send?

At least 10 characters.

So we can reply. Not used for anything else.